Saba CD 360

I replaced the C1003C2 IC, but the fault still exists. The IC chip is normal. The main motor does not rotate, and the rewind motor is normal.

I am currently searching for any faults in the motor drive section based on the circuit diagram.

Reporting good news, after a day of searching, the fault was finally found,

A 620 ohm resistor on this small circuit board has broken, which is very concealed and difficult to detect. I measured the resistors one by one and found that there is no data for this resistor. Upon closer inspection, it has broken.

I am very happy, thank you very much for your guidance. Every time I encounter difficulties, I come to the forum and you have given me enthusiastic guidance. Thank you again.

You are Welcome!

Best Regards
Reinhard